6 of 10
ISSUED: 05-02-06 SHEET #: 202-9112-4 06-29-11
Snap four cable management clips (
R
) into top or bottom of arm assembly (
C
) as shown
.
Cable ties (
S
) are
used with clips for cord management.
Slide one mesh sleeve (
T
) over each cable. Use cable ties (
S
) to tighten mesh sleeves to cables.
3
3-1
Note: There are fi ve mounting positions. The
center position is shown (right).
Slide washer
(
J
) over wall support arm axle (
D
). Next, insert
plastic cap (
N
) into axle. Then, insert holding pin
(
M
) into axle. See detail 1.
Note:
Fit of axle (
D
) into wall plate (
A
) and arm
assembly (
C
) will be tight. Gently tap into place
with a hammer if necessary.
2
2-1
Insert socket cap screw (
K
) into hole at bottom
of wall support arm axle (
D
) as shown in detail 3.
Tighten screw using 9/64" allen wrench (
Q
).
Place arm assembly (
C
) with washer (
J
) into wall
plate (
A
). Insert axle assembly shown in detail
1 through wall plate (
A
), arm assembly (
C
), and
washer (
J
). Lock axle in place by aligning holding
pin (
M
) with notches shown in detail 2.
2-2
• If you are uncertain that product is properly installed, call customer care.
WARNING
K
D
N
J
D
M
J
C
DETAIL 3
A
DETAIL 1
DETAIL 2
NOTCH
R
C
T
S