5 of 7
ISSUED: 06-04-10 SHEET #: 120-9083-2 05-14-12
begin with the shortest length screw, hand thread through multi-washer and tilt bracket into screen as shown
below. Screw must make at least three full turns into the mounting hole and fit snug into place. Do not over tighten.
If screw cannot make three full turns into the screen, select a longer length screw from the baffled fastener pack.
Repeat for remaining mounting holes, level brackets and tighten screws.
NoTe:
Spacers may not be used, depending upon the type of screen.
NoTe:
If using M10 x 15 mm penta-pin scres (
ee
) tighten screws with M10 penta-pin driver (
DD
).
begin with longer length screw, hand thread through multi-washer, tilt bracket and spacer in that order into screen
as shown below. Screw must make at least three full turns into the mounting hole and fit snug into place. Do not
over tighten. If screw cannot make three full turns into the screen, select a longer length screw from the baffled
fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.
NoTe:
If using M10 x 15 mm penta-pin scres (
ee
) tighten screws with M10 penta-pin driver (
DD
).
For Flat Back Screen
For Bump-out or Recessed Back Screen
TILT bRACkET
(
AA
or
BB
)
SCREEN
fig. 2.1
SCREw
1-1
1-2
If you have any questions, please call Peerless customer care at 1-800-865-2112.
If you have any questions, please call Peerless customer care at 1-800-865-2112.
MULTI-wASHER
SCREEN
SCREw
TILT bRACkET
(
AA
or
BB
)
fig. 2.2
SPACER
MULTI-wASHER
