Copyright ® Holz-Hoerz
Seite 6 von 8
Stand: 4.2.2013 He/131114ph_e
Warning! For the use of this device a certain degree in motor abilities and circumspection is
assumed. In case of doubt first use device only with assistance and wear appropriate protective
clothing and gear if necessary.
Maximum load 100 kg (120 kg without guaranty).
Even it is among others also a game device for children, the assembly always should be done or
supervised from an adult.
While using the Innensechskant, please pay attention to hold it straight and deep in the head of the
screw. Otherwise the screw can be damaged. Draw the screws firmly. The head of the screw should be
a little bit imprinted in the wood.
After longer or frequent use you should control all screws and screw them up if necessary.
Protect the device for damp and wet.
Oiled or wooden parts can be wiped moistly. If stronger soiled wooden parts can be reworked with
steel wool or find sandpaper. Afterwards apply again with nature oil or wax thinly.
Assembly:
Step 1: Fastening of the four feet with 8 pcs. flat-head screws M6x6 cm, 8 pcs. nuts M6 and 16 pcs. washers:
The baseboards are screwed together from the outside, broadside on broadside on the pre-assembled folding
stand strips, on 2 screws M 6 x 6 cm. Feet overlap with 13 drilled holes. Each foot a screw in the 1st and 13th
hole. Under the screw head and under the nut a washer should be laid. Pull all screws firmly.
Step 2:
The safety hook have to be screwed on the wooden disk
firmly by using suitable tools.
Thereby please note the following
order:
Screw the nut maximal on the safety hook
attach the wooden ball
loosely and screw on the next following nut only by hand
completely
put on washer, wooden disk, washer
screw on nut
and next following nut by using tool.
Make sure that the nuts between the safety hook and the wooden
disk are firmly tightened. Both nuts upside the wooden disc must be
countered. To this it is necessary to clip the first nut with a flat
wrench and then turn the second nut with the second wrench
against the first nut firmly. Thus countered the nuts cannot free
themselves by itself!!
The wooden ball need not to be clamped, it
only serves as spacer in this Pyramido® rack
Now the safety hook with wooden disk may be inserted from the top
between the hinges (safety hook points downwards) in the
Pyramido® rack.
<< Counter these
<< two nuts!!
