6
Manual: Heating Insert P – Lab-Tek™ type
www.pecon.biz
12.01.2004
Assembly:
tempcontrol 37-2
37.0 37.0
on
power
off
°C
digital
1
2
E
+
+
+
+
+
+
perfusion
perfusion
s = spring clamping
l-s
l-s
l-s
l-s
l-s = levelling-screw
s
•
Put the Heating Insert P into Scanning Stage or Mechanical Stage. The levelling can be adjusted
to the optical axis with the four screws "l-s".
•
Plug the 8-pin connector into the socket of a free channel of the Tempcontrol 37-2 digital
(# 0503.000) or Tempcontrol 37-2 analog (# 502.000) and secure it by clockwise rotation.
Operation:
•
Set the desired temperature value on the Tempcontrol unit and switch-on the heating (see
manual Tempcontrol).
•
When combined with the Incubator S the observation window should be closed
with the red insert (# 0426.103) if no cell cultivation chamber is used to maintain
air composition.
Use of different cell cultivation systems in the Heating Insert P (see also page 9):
•
Lab-Tek™ (Nunc
®
):
1. Insert the Lab-Tek™ adapter as shown. The
rounding with the slot should face towards
the inside for easier removal of the adapter.
2. First put the chamber inclined below the spring clamping
and slide it back (1), then push the chamber to the bottom
(2).
1
2
•
Chamber Slides (Nunc
®
/ Falcon
®
) – see also page 8:
1. Insert the spacer as shown. The round pin
should sit firmly in the right opening.
2. First put the chamber inclined below the spring clamping
and slide it back (1), then push the chamber to the bottom
(2).
2
1
