Peco Z Trimmer ZT-3000, Руководство оператора

Страница: 6 / 20

6
Section 2 Installation For Use
Pivot Block Assembly Installation
Position and place the Pivot Spring (Item #) over the Pivot Bushing of the Base Plate Assembly (Item #3). Position the
top end of the Pivot Spring over the right side of the Spring Bracket of the Base Plate Assembly and the lower end of
the Pivot Spring over the bottom left side of the Spring Bracket. Refer to Figure A.
Note: Some parts and part features have been hidden from view from each respective view for visual clarity.
Next, position the Pivot Block Assembly (Item #1) aligning the Pivot Bushing of the Base Plate Assembly to that of the
Pivot Block Bushing of the Pivot Block Assembly, and at the same time, aligning and positioning the Pivot Pin in
between the Pivot Spring. Refer to Figure B.
Refer to Figure C.
Finally, secure the Pivot Block Assembly to the Base Plate Assembly by
using (1) 5/16”-18 x 3/4” HHCS (Item #4) and (1) 3/8” Flat Washer (Item #5).
Figure A Figure B
Figure C
Assembled View
Exploded View
Refer to Page 16 for the exploded view of the
Pivot Block Assembly P#(ZTA-0004_01)