Peco 51031201, Руководство оператора, Страница: 5 / 24

5
Section I
INTRODUCTION AND
DESCRIPTION
1-1 Introduction
We are pleased to have you as a PECO customer. Your
collection system has been designed to give you a low
maintenance, simple, and effective way to collect the
grass clippings from your mower. This manual is
provided to give you the necessary instructions to
properly mount and operate the collection system on
your mower. Please read this manual thoroughly.
Understand what each control is for and how to use it.
Observe all safety decal precautions on the machine and
noted throughout the manual.
NOTE: All references made to right, left, front, rear, top
or bottom are as viewed from the normal operator’s
position on the mower.
1-2 Description
The collection system is designed for turf maintenance
where there is a need to collect the grass clippings as
the mower cuts the turf. The collection system is also
good for picking up leaves and twigs in pre-season and
post-season clean-up.
The deck drive assembly is mounted on the right side of
the mower deck. The deck drive assebly draws grass
clippings from the discharge area of the cutter deck back
to the (3) 2.9 cubic foot collection bags P#(G0004) at the
rear portion of the mower frame. Once the bags are full,
they can be released for easy dumping.
Section II
INSTALLATION FOR USE
2-1 Preparation Of Mower
Carefully dismantle wooden the shipping crate from
around the components. Cut the retaining straps and
separate the parts. The collection system will have
various parts located inside. Remove and sort all parts
for easy identification.
NOTE: Before each step of assembly it will help to study
the part drawings on pages 11 thru 18.
Grass Deflector Removal:
Remove the (2) 3/8”-16 x 1-1/4” HHCS, (2) 3/8” spring
washer, and (2) 3/8”-16 nyloc nut that secure the grass
deflector to the mower deck (Figure 2-1). Remove the
grass deflector from the mower deck. Once the grass
deflector is removed, follow the instructions included in
your Walker owners manual, and raise the mower deck.
Deck Preparation:
Drill (4) 5/16” holes into the front edge of the mower
deck. From the front of the mower, measure 1-1/2” up
from the deck bar, and 1-3/8” from the right caster and
mark the deck. Measure 19-1/8” to the right of your first
mark and 1-1/2” up from the deck bar and mark the
deck. Refer to Figure 2-1b.
From the front of the mower, measure 1-1/2” up from the
deck bar and 1-1/2” from the left caster and mark the
deck. Measure 18-1/8” to the left of your third mark and
1-1/2” up from the deck bar and mark the deck. Refer to
Figure 2-1c.
Remove
Grass Deflector
Figure 2-1a
Figure 2-1b
19-1/8”
Between Holes
1-3/8”
From Caster
1-1/2”
From Bar
Bar
Figure 2-1c
18-1/8”
Between Holes
1-1/2”
From Caster
1-1/2”
From Bar
Bar