Peco 38621241, Руководство оператора

Страница: 8 / 26

8
Install the Lower Main Frame P#(B0567) by attaching to the ROPS (Roll Over Protection System) using (1) 3/8”-16
x 2-1/8” x 2-5/8” U-Bolt P#(K1119) and (2) 3/8”-16 Ny-Flange Locknuts P#(K2038) on each side. Secure the back
section using the Frame Mount Spacer P#(B0777) and the Main Frame Clamp P#(B0302) with (2) 3/8”-16 x 1”
HHCS P#(K1191) and (2) 3/8”-16 Ny-Flange Locknuts P#(K2038). Refer to Figure 2-5b
Attach the Main Frame Assembly P#(A1097) to the Lower Main Frame P#(B0567) using (4) 1/2”-13 x 1-1/4” HHCS
P#(K1232) and (4) 1/2”-13 Ny-Flange Locknuts P#(K2012). Use the middle set of mounting holes on the Main
Frame Assembly and the front set of mounting holes on the Lower Main Frame. Refer to Figure 2-5c on next page.
2-5 Main Frame Assembly Installation
ROPS
U-Bolt
Frame Mnt.
Spacer
Main Frame
Clamp
Blower
Cone Tabs
Blower
Cone
Figure 2-4
(2) 5/16”-18 x 2-1/2”
All Thread HHCS
(2) 5/16” Jam Nuts
2-4 Blower Cone Installation
Thread (1) 5/16”-18 Jam Nut P#(K0120) onto the end of each (2) 5/16”-18 x 2-1/2” HHCS P#(K0125). Now
partially thread the bolts into each of the two tabs located on the Blower Housing. Place Blower Cone
P#(E6009) so the two tabs line up with the bolts then tighten completely. See Figure 2-4.
Figure 2-5b