Peco 28621206, Руководство оператора

Страница: 5 / 20

5
SECTION I
INTRODUCTION AND DESCRIPTION
1-1 Introduction
We are pleased to have you as a PECO customer. Your
collection system has been designed to give you a low
maintenance, simple and effective way to collect the
grass clippings from your mower. This manual is
provided to give you the necessary instructions to
properly mount and operate the collection system on
your mower. Please read this manual thoroughly.
Understand what each control is for and how to use it.
Observe all safety decal precautions on the machine and
noted throughout the manual.
Note: all references made to right, left, front, rear, top or
bottom are as viewed from the normal operator’s
position on the mower.
1-2 Description
The collection system is designed for turf maintenance
where there is a need to collect the grass clippings as
the mower cuts the turf. It is also good for picking up
leaves and twigs in pre-season and post-season clean-
up.
The engine/blower/blade assembly, is mounted on the
right side of the unit. The blower draws grass clippings
from the discharge area of the cutter deck up to the
aluminum container mounted over the rear portion of the
frame. The operator can engage the
engine/blower/blade assembly by starting the engine.
Once the container is full of clippings, the operator can
easily push and raise the lift handle, releasing the
container’s rear door and the container will pivot towards
the ground.
Section II
INSTALLATION FOR USE
2-1 Preparation Of Mower
Carefully dismantle wooden shipping crate from around
the components. Cut retaining straps and separate the
parts. The collection system will have various parts
located inside. Remove and sort all parts for easy
identification.
NOTE: Before each step of assembly it will help to study
the exploded drawings on pages 8 and 9.
Remove the existing hardware and rear bumper of the
mower as shown in Figure 2-1.
2-2 Lower Mount Bracket Assembly
Installation
Fasten the left and right lower mount bracket assemblies
P#(A0839 & A0840) to the rear frame of the mower, using
the existing hardware and (2) M10-1.25 x 20MM HHCS
P#(K1269).
2-3 Top Main Frame Assembly
Installation
NOTE: It is recommended that you have someone
assist you in mounting the top main frame assembly.
Lift the main frame assembly P#(A0228) and align the
mounting holes located on the mount bracket assembly
P#(A0257) with the holes on the main frame assembly.
Figure 2-1.
Rear Bumper
Remove Hardware
On Both Sides
Figure 2-2.
A0839
(2) M10-1.25 x 20MM HHCS
A0840
Existing
Hardware