Peavey PV 1, Руководство пользователя

Страница: 6 / 12

6
4. Connecting the Audio Output
The PV
®
-1 receiver provides both a fixed mic level BALANCED AUDIO OUTPIT XLR (14) and an
adjustable line level UNBALANCED AUDIO OUTPUT ¼” JACK (13). The level from the
UNBALANCED OUTPUT is controlled by the rear panel VOLUME CONTROL (6). (Note: As
when making any connection, make sure the amplifier or mixing board volume is at the minimum
level before plugging in the receiver to avoid possible sound system damage.)
Instrument Connection (using the PV-1 instrument transmitter)
Insert an audio cord with a ¼” mono phone plug in the UNBALANCED OUTPUT JACK (13)
on the rear panel of the receiver. Plug the other end of the cord into an amplifier, effects, or
mixing board. Adjust the VOLUME CONTROL (6) on the PV-1 receiver clockwise until the
volume level is comfortable for your application. This setting is roughly equivalent to a direct
instrument cord connection.
A. Microphone Connection (using the PV-1 transmitter with either a headset or lavalier
microphone or the PV-1 handheld microphone transmitter)
For microphone use, either the BALANCED MIC AUDIO OUTPUT XLR (14) or the ¼” line
level UNBALANCED OUTPUT (13) can be used. The XLR output is set at a non-adjustable
microphone level, similar to hardwired mic levels. Plug an XLR connector into the XLR output
jack on the rear of the unit and plug the other end into your amplifier or mixing board. (Note:
Make sure mixing board is turned off and the volume is turned down when making
connections.) For your convenience, the XLR output level is preset at the factory and is not
adjustable with the receiver volume control. To use the ¼” UNBALANCED OUTPUT JACK
(13), follow the instructions for the Instrument Connection (above), except start with the
receiver volume at ½” MAX and adjust the volume control until the volume level is optima. If
the volume control is set too high, you may overload your mixer or amp.