6
Rear Panel
AC POWER INLET (5)
This is the receptacle for an IEC line cord, which provides AC power to the unit. Connect the
line cord to this connector to provide power to the unit. Damage to the equipment may result if
improper line voltage is used.
Never break off the ground pin on any equipment. It is provided for your safety. If the outlet
used does not have a ground pin, a suitable grounding adapter should be used and the third wire should be grounded
properly. To prevent the risk of shock or fire hazard, always make sure that the amplifier and all associated equipment is
properly grounded.
NOTE: FOR U.K. ONLY
As the colors of the wires in the mains lead of this apparatus may not correspond with the colored markings identifying
the terminals in your plug, proceed as follows: (1) The wire which is colored green and yellow must be connected to the
terminal which is marked by the letter E, or by the Earth symbol, or colored green or green and yellow. (2) The wire which is col-
ored blue must be connected to the terminal which is marked with the letter N, or the color black. (3) The wire which is colored
brown must be connected to the terminal which is marked with the letter L, or the color red.
To avoid the risk of electrical shock, do not place fingers or any other objects into empty tube sockets while power is being
supplied to unit.
FAN GRILLE (6)
A two-speed DC fan supplies cool air to the amplifier. THIS INTAKE SHOULD NEVER BE BLOCKED! The fan switches to high
speed automatically when the unit requires additional cooling. At idle and cool, the fan runs at low speed. The fan should never
stop unless the amplifier is switched OFF or the AC mains power source is interrupted, or if both back panel circuit breakers have
tripped.
Bannana Jack Binding post Speaker Connector (7)
These connectors will accept bannana connectors or wire and can be used instead of the twist lock connectors for connecting
speakers to the amplifiers.
Primary Circuit Breakers (8)
The CS 6000/ CS 4000 has separate power supplies for each channel each protected from overload with its own circuit breaker.
Efforts
should be made to correct the cause of the overload, first by disconnecting one output at a time, and then one speaker at a time until
the bad cable or damaged speaker is isolated. If the fuse opens instantly each time you attempt to turn the unit on, it should be taken to
a qualified Peavey Service Center for repair.
OVERLOAD
CHANNEL A
LEVEL
(dB)
0
6
16
20
23
26
29
+32
OVERLOAD
LEVEL
(dB)
0
6
16
20
23
26
29
+32
CHANNEL B
CS 6000
INPUTS
CHANNEL A
CHANNEL A
CHANNEL B
BREAKER
20A 250V
BREAKER
20A 250V
CHANNEL B
LINE OUTS
BRIDGE
DDT
TM
ENABLE
DEFEAT
BRIDGE
SPEAKER OUTPUTS
CLASS 3 WIRING
BRIDGE
+
+
+
_
_
_
A
B
+
-
+
-
GND
40 Hz
150 Hz
X-OVER
HIGH
OUT
LOW
OUT
THRU
40 Hz
150 Hz
X-OVER
HIGH
OUT
LOW
OUT
THRU
STEREO
BRIDGE
The power only breaks
one side of the AC mains.
Hazardous energy may be
present in the enclosure when
the power switch is in the OFF
position.
5
8
10
15
11
12
9
7
6
14
11
13
9
9
