Peavey 6505 SUB, Руководство по эксплуатации

Страница: 3 / 8

6505 ® Sub Lower Rear Panel
6505 ® Sub Upper Rear Panel
* FUSE
The unit is AC power line fuse protected from overloads and fault conditions with a fast-blow 3.15 Amp fuse. This fuse is located
within the enclosure, on the amplifier chassis. If the fuse fails, THE FUSE MUST BE REPLACED WITH THE SAME TYPE AND
VALUE IN ORDER TO AVOID DAMAGE TO THE EQUIPMENT AND TO PREVENT VOIDING THE WARRANTY. If the unit
blows a fuse, it should be taken to a qualified service center for repair.
IEC POWER CORD CONNECTION (1)
This receptacle is for the IEC line cord (supplied) that provides AC power to the unit.
It is very important that you ensure the 6505® SUB has the proper AC line voltage supplied.
You can find the proper voltage for your 6505® SUB printed next to the IEC line (power) cord on the rear panel of the unit.
Please read this guide carefully to ensure your personal safety as well as the safety of your equipment.
Never break off the ground pin on any equipment. It is provided for your safety. If the outlet used does not have a ground pin, a
suitable grounding adapter should be used and the third wire should be grounded properly. To prevent the risk of shock or fire
hazard, always be sure that the signal source, andor mixer and all other associated equipment are properly grounded.
ON-OFF SWITCH (2)
This rocker switch supplies AC power to the 6505® SUB when switched to the ON position.
1
2
POWER
ON
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, THIS APPARATUS
WARNING:
SHOULD NOT BE EXPOSED TO RAIN OR MOISTURE AND OBJECTS FILLED WITH LIQUIDS,
SUCH AS VASES, SHOULD NOT BE PLACED ON THIS APPARATUS.
AVIS:
ELECTRIQUE, CET APPAREIL NE DOIT PAS ETRE EXPOSE A LA PLUIE OU A L’HUMIDITE ET
AUCUN OBJET REMPLI DE LIQUIDE, TEL QU’UN VASE, NE DOIT ETRE POSE SUR CELUI-CI.
DANS LE BUT DE REDUIRE LES RISQUES D’INCENDIE OU DE DECHARGE
100-120V
50/60Hz
110 WATTS
0
1
2
3
4 5 6
7
8
9
10
GRND LFT
THRU/HPF
(SPEAKER LEVEL)
INPUT LEVEL THRU/HPF
INPUT
SUBWOOFER
Consumo de energia 110Wh
CAN-ICES-3(B)/NMB-3(B)
PEAVEY ELECTRONICS CORPORATION
5022 HARTLEY PEAVEY DRIVE
MERIDIAN, MS 39305
CAUTION
AVIS:
RISQUE DE CHOC
ELECTRIQUE-NE PAS OUVRIR
POWER
ON
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, THIS APPARATUS
WARNING:
SHOULD NOT BE EXPOSED TO RAIN OR MOISTURE AND OBJECTS FILLED WITH LIQUIDS,
SUCH AS VASES, SHOULD NOT BE PLACED ON THIS APPARATUS.
AVIS:
ELECTRIQUE, CET APPAREIL NE DOIT PAS ETRE EXPOSE A LA PLUIE OU A L’HUMIDITE ET
AUCUN OBJET REMPLI DE LIQUIDE, TEL QU’UN VASE, NE DOIT ETRE POSE SUR CELUI-CI.
DANS LE BUT DE REDUIRE LES RISQUES D’INCENDIE OU DE DECHARGE
100-120V
50/60Hz
110 WATTS
0
1
2
3
4 5 6
7
8
9
10
GRND LFT
THRU/HPF
(SPEAKER LEVEL)
INPUT LEVEL THRU/HPF
INPUT
SUBWOOFER
Consumo de energia 110Wh
CAN-ICES-3(B)/NMB-3(B)
PEAVEY ELECTRONICS CORPORATION
5022 HARTLEY PEAVEY DRIVE
MERIDIAN, MS 39305
CAUTION
AVIS:
RISQUE DE CHOC
ELECTRIQUE-NE PAS OUVRIR
5
3
4
6 7 8
GND LIFT SWITCH (3)
Switches the XLR (5) PIN 1 from direct contact with ground in the event that hum occurs.
THRU / HIGH PASS FILTER SWITCH (4)
Switches the THRU/HPF output jack between a full-bandwidth thru, or a high-pass out with a corner frequency of 120 Hertz for
connection to the amplifier of a speaker to carry the upper frequency range.
XLR INPUT (5)
This line-level balanced XLR input is of the medium impedance (10k) balanced type.