Pearl VX10.2XLPROR, Руководство владельца/оператора

Страница: 10 / 24

– 10 –
9. Extension Cords
• Always use the extension cord included with
the saw.
• If an additional extension cord is needed, use
only a cord that is intended for outdoor use.
These extension cords are identified by the
marking “Acceptable for use with outdoor
appliances; store indoors while not in use.”
Use only extension cords with an electrical
rating higher than the rating of the tool. Refer
to the chart on page 14. Do not use damaged
extension cords. Examine an extension cord
before use and replace it if it is damaged. Do
not abuse extension cords and do not pull on
any cord to disconnect it. Keep the cord away
from heat and sharp edges. Always
disconnect the extension cord from the
receptacle before disconnecting the saw from
the extension cord.
• Never use an additional extension cord that is
longer than 50 feet.
10. Always use the Ground Fault Circuit Interrupter
(GFCI) plug included with the saw.
11. The tile saw cord includes a 15-amp twist lock
plug. Do not modify this plug or use an adaptor
on it. This plug is intended to be used with the
GFCI Plug included with the saw. The GFCI has
a standard 3-prong plug that can be plugged
into a standard 3-prong outlet or extension
cord.
Features:
• Cutting table marked in inches for precision
cuts.
• 14” cutting table provides more support during
larger cutting jobs than the standard 11”
cutting tables.
Using 90˚ Rip Guide:
1. Set the rip guide by positioning it on the
desired dimension and tighten the threaded
knob. Make sure that the rip guide is firmly
tightened to avoid slippage. The rip guide can
be used for 90˚ rip cuts from both the left and
right side.
2. After the rip guide is positioned for the desired
cut, place material flat against the rip guide and
the table measurement rail.
3. Simply line-up the material being cut with the
appropriate pre-marked lines on the cutting
table surface.
4. Now you are ready to make your cut.
Making Miter Cuts (Using Optional Miter Block):
1. For miter cuts, place the lip of the miter block
on the measurement rail, with the threaded
knobs facing you.
2. Tighten the threaded knobs to secure the miter
block in place.
3. Place material onto miter block and you are
ready to cut.
ix. USING THE CUTTING TABLE
Figure 4
Cutting large tile
VX10.2XLPROR can cut a 24" tile and
diagonally cut a 18" tile.
To reduce the risk of electrocution, keep
all connections dry and off the ground.
Do not touch plug with wet hands.
TOOL
Figure 3
Drip Loop
Supporting
Surface
Power Cord
Drip Loop
GFCI/Power Cord
Connection
GFCI plug