Wing Bolt
Setting the Snare Drum
1. Adjust the position of the
Stability Arm so that the
Support Bumper is just
in front of the Snare
Arms as shown. (Fig.6)
2. Spread the Snare Arms and attach the Snare Drum
facing the direction shown in Fig. 7-B.
3. Loosen the Key Bolt on the Support Bumper and adjust
its position up or down so that it is touching the bottom
hoop of the snare drum. (Fig.7-A, 7-B)
4. Press the Support Bumper
against the bottom hoop and
tighten the Wing Bolt . (Fig.8)
Note
・
This stand is designed to be used with snare drums with CXSA-1
or MXSA-1 attachment. Snare drums other than these could result
in unstable settings and should not be used.
・
Do not overtighten the Key Bolt on the Support Bumper. The
Support Bumper will deform and would become stuck on the
Stability Arm.
・
Do not use on unstable or sloped surfaces, as it could
cause the stand to fall, resulting in damage and/or
injury.
・
Do not make adjustments on the Base Section with the
Top Section inserted.
・
Do not move the stand with the Snare Drum mounted
on the stand.
・
Before use, check all Stop Locks to assure they are
properly positioned and secured.
・
Do not mount the Snare Drum without the Support
Bumper. The Snare Drum could become unstable and
could cause damage and/or injury.
・
Periodically check all Wing Nuts, Wing Bolts and the
nuts under the Snare Arm to assure they are tightened
securely.
・
When making adjustments, support and control the
parts being adjusted to prevent them from falling or
pinching fingers that may be in the way.
・
When folding the legs, be careful not to pinch your
fingers between the leg and the stand.
・
When handling tubular hardware, do not put your
fingers into the tubes top prevent injury to your fingers.
CAUTION
http://www.pearldrum.com
Products and specifications are subject to change without notice.
Printed in
China
-1406-
Stability
Arm
Support
Bumper
Snare Arm
Key Bolt
Support
Bumper
Support
Bumper
Bottom
Hoop
Support
Bumper
Fig.7-A
Fig.6
Fig.8
Fig.7-B
