In the initial factory setting, the
Index Mark is centered in the
Window as shown (Fig. 2).
Index Mark
Initial
Setting
Beater Holder Link
Beater Holder Link
Key Bolt
Beater Setting Stopper
Control Core Beater
Key Bolt
Drum Key
Beater Setting Stopper
Allen Screw
Beater Holder Link
Fig. 2
Fig. 1-B
Fig. 1-A
Fig. 3
Fig. 4-A
Fig. 6
Control Core Beater Setting
Insert the Control Core Beater into the Beater Holder Link
until it stops against the Beater Setting Stopper, and tighten
the Key Bolt with the provided Multi Function Drum Key
(Fig.1-A). Make sure that the Beater Setting Stopper is flush
against the Beater Holder Link with the flat face square
against the Notch (Fig.1-B).
To change to a higher or shorter beater height, loosen the
Allen Screw on the Beater Setting Stopper with the provided
Multi-Function Drum Key or Allen wench (3mm) then loosen
the Key Bolt on the Beater Holder Link (Fig. 3). Set the
beater to the desired height and re-tighten the Key Bolt.
Reset the Beater Setting Stopper flush against the Beater
Holder Link per the instructions above.
Beater Stroke Adjustment
The P-3002C Demon Chain Double Pedal features Pearl's
patented two-position Beater Holder that can be positioned
closer or farther from the drum head for Finesse "A" Position
setting or Power "B" Position setting respectively.
It also rotates infinitely for perfect beater angle without
changing the footboard angle.
Changing the Beater Holder Position
To change to the Power setting, loosen the Key Bolt to open
the clamp and slide the Beater Holder to the Power setting
position (Fig.4-A, 4-B). There is no need to remove the Key
Bolt from the clamp.
Beater Angle Adjustment
To change the angle of the Beater, loosen the Key Bolt and
set the angle to your preference and re-tighten the Key Bolt
(Fig.5).
Fig. 4-B
"B" Position (Power)
"A" Position (Finesse)
The Beater Setting Stopper preserves the height setting if the
beater is removed when transporting the pedal.
Indicator marks are provided for referencing Beater angle settings
(Fig.6).
Tip
Tip
Tip
Tip
The Beater Holder is set at the factory in the Finesse "A" Position.
Fig. 5
A
B
Index Mark
