Pearl CM-127, Инструкция по эксплуатации

Страница: 10 / 20

9
(8) When you can see the crosshairs, tighten the lock knob to fix the position of the microscope.
*1: If you cannot see the crosshair image even after moving the microscope all the way up, lower
the microscope and loosen the barrel. Then raise the barrel.
After you can see the crosshairs, secure the barrel and then adjust the focus again by turning
the fine adjustment handle.
*2: If you cannot see the crosshair image after following the procedures in *1 above, turn the
collimating adjustment ring left or right. Then start again at step (6) above.
Note: Turning the fine adjustment handle while the lock knob is tightened will damage the main
housing.
Lift the barrel up
Loosen the barrel
clamp