Align this line with the batter side edge of the Bass Drum.
Make sure that the Stop Lock, Key Bolt, Wing
Bolt and Wing Nut are tight and secure before
use.
When adjusting the height of the Cymbal
Holder, make sure to hold the Joint section of
the Upper Pipe Assembly. The Upper Pipe
Assembly Collar features a plastic insert and
care should be taken to not drop the collar on
to the L-Rod during assembly. Doing so may
result in damage to the plastic insert.
DO NOT attach the Bracket where it could
produce undue stress or damage to the Bass
Drum shell.
DO NOT attempt to carry the Bass Drum using
the Cymbal Holder or lean into the Cymbal
Holder. Doing so would result in damage to the
Bass Drum.
Pearl cannot be held responsible for any
damage sustained to the Bass Drum, personal
property or bodily harm during use of this
product. Pearl warranty will not cover damage
to Pearl Bass Drum from abuse or misuse of
this product.
Mounting Screw Hole
Cut for Stop Lock
Mounting Screw
Batter Side
Front Side
Upper Pipe Assembly
L-Rod
Bracket
Wing Nut
Wing Bolt
Key Bolt
Stop Lock
Fig.3
Fig.4-A
CHB-830
Hole Position Template
(full scale)
48mm
65mm
Bracket
Fig.4
Fig.2
Installing the Bracket to Drum Shell
Remove the Mounting Screws from the Bracket. Place
the Bracket with rubber gaskets attached, to the Bass
Drum as shown (Fig.2) Position the Bracket with the
Stop Lock cut out towards the front of the drum (Fig. 3.)
Reattach the mounting screws using a Phillips head
screwdriver and tighten. Check Bracket to ensure it is
secure and replace drum head and hoop.
<< Assembling the Cymbal Holder >>
Insert the L-Rod with the knurled end into the Bracket
as shown in (Fig 4.) and tighten the Wing Nut on the
Bracket. The L-Rod is equipped with a Stop Lock to
prevent the Cymbal Holder from moving and retain
setting during kit setup and dismantle. Before using,
make sure that the Stop Lock is securely set within the
cut-out on the Bracket, then tighten the Key Bolt on the
Stop Lock using a Drum Key (Fig.4-A). Place the Upper
Pipe Assembly on to the L-Rod and tighten the Wing
Bolt (Fig.4). Install Cymbal and adjust the position and
angle to your preference.
8.5mm
50mm
Bass Drum Lug
Bracket
Recommended
Mounting Position
8.5mm
CAUTION
Mounting Screw Hole
