ASSEMBLY INSTRUCTIONS
1.
Unpack the contents of the box and check to make sure that all items are accounted for and in good condition.
2.
Select a flat, level surface for the assembly and final location of your fountain.
3.
Place the main body on a flat, level surface.
From the opening at the back of the fountain, insert the water supply tube into the pump outlet on
the top of the pump and connect the LED lights with the light cable separately
.
. Please place the pump upright into the basin and draw the pump
power cord out through the opening and connect it to the transformer.(Fig. 1& Fig.2)
4.
Add clean water into the basin. The
required water volume is 7 liters (1.85 gallons) or the water level should be approximately 1 in. / 25 mm
lower than the top edge of the opening at the back of the basin. (Fig.3)
5.
Connect the transformer to a GFCI outlet and the product will begin to function as intended. (Fig. 3)
6.
If the pump runs with low or high water circulation Check and adjust the regulator dial or slide on the front of the pump. Adjust the dial/slide
towards (+) to increase water flow or towards (-) to decrease water flow. (Fig. 4)
7.
The LED lights were pre-assembled, but they are replaceable . When replace them ,please refer to Fig.1.
8.
To eliminate the possibility of water damage around your fountain, check for leaks and excessive splashing after the initial setup of your fountain.
It is highly recommended that this fountain be placed in an area where it cannot be damaged that might cause damaged with the fountain .
9.
Do not leave your fountain running for extended periods of time when no one is present to observe the performance.
10.
Check the area around your fountain on a regular basis to ensure that there is no leakage.
NOTE: The diagrams shown are for illustrative purposes only and are not to scale
IMPORTANT SAFETY INSTRUCTIONS FOR TRANSFORMERS
When using electrical products, basic precautions should always be practiced including the following:
1.
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
2.
Read and follow all instructions that are on the product or provided with the product.
3.
For a cord-connected or direct plug-in power unit, do not use an extension cord.
4.
Reference the National Electrical Code, ANSI/NFPA 70, specifically for the installation of wiring and clearances from power and lighting
conductors.
5.
Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable codes and standards, including
fire-rated construction.
6.
For a cord-connected or direct plug-in power unit, do not install or use within 3.05 m / 10 ft of a pool.
7.
For a cord-connected or direct plug-in power unit, do not use in a bathroom.
8.
For a cord-connected power unit, user should pay attention to below statement
WARNING:
Risk of Electric Shock. When used outdoors, install only to a covered Class A GFCI protected receptacle that is weatherproof
with the power unit connected to the receptacle. If one is not provided, contact a qualified electrician or proper installation. Ensure that the power
unit and cord do not interfere with completely closing the receptacle cover.
9.
WARNING:
Risk of Fire. Installation involves special wiring methods to run wiring through a building structure. Consult a qualified
electrician.
10. For a unit intended to be mounted greater than 0.3 m / 1 ft from the ground surface:
WARNING:
Risk of Electric Shock. Mount the unit at a height greater than 0.3 m / 1 ft from the ground surface.
SAVE THESE INSTRUCTIONS
. This manual contains important safety and operating instructions for power units
4
