PEAKnx PNX-005-A17-00001, Руководство пользователя

Страница: 8 / 16

USB-Connector, User Manual
8
Note
: The USB-Connector can only be connected to the DIN rail adapter via the adapter
cable.
5 Start-up
Note:
If you want to operate more than one KNX-IP Router in the same KNX network, the mul-
ticast addresses must be different. If they both communicate over the same multicast address,
this will result in a circulating message.
Note:
Keep the USB-Connector away from water and moisture!
The software required to use the USB-Connector is located on the USB flash drive supplied.
The software package includes an IP Router, a Bus Monitor and an ETS integration tool that
allows the use of the USB-Connector if the IP Router software is not installed.
5.1 Installing the Bus Monitor and IP Router software
To install one or both components, proceed as follows:
■
Run the “PEAKnx USB Connector” application stored on the USB flash drive to start the
installation wizard.
■
Open the tab “Install”.
■
Run the “Setup Wizard”.
■
Follow the installation instructions.
During installation, you will be asked whether you want to install the Bus Monitor
software and/or the IP Router software, so you can also install only one of the two
components.
5.2 Using the USB-Connector exclusively with the ETS
The ETS Integration is a small tool for a one-time run on a computer, which configures the
local ETS-Installation, so that it can be used together with the KNX-USB-Connector. To do
this, the ETS must already be installed on the computer. It is automatically installed by the
installation wizard when the IP Router and Bus Monitor are installed. If you want to use the
USB-Connector exclusively with the ETS, you can also run the ETS integration tool on its
own.