How to use your laminator
1) Carefully remove the laminator from all of its packaging and place it on a flat, level surface. Make sure
you keep the original packaging somewhere safe (in case this is needed in the future).
2) Unpack the power cable and insert it into the power outlet at the back of the laminator. Plug it in to a
power socket. Press the POWER switch to turn the laminator on. The light will illuminate.
3) Check that the FWD/REV (Forward and Reverse) switch is set to FWD (See diagram 1).
5) Set the HEATER switch to ON.
6) The laminator will now begin to heat. Once it has reached the set temperature, the READY light will
illuminate.
7) Place the document you are laminating inside the pouch, making sure that it is centrally positioned
and that a small border (approx 3-5mm) is left around the edge.
8) Once the document is positioned in the pouch. Insert the prepared document into the laminator. Make
sure you insert the SEALED EDGE FIRST and do not insert at an angle. The item will automatically feed
through and appear the other end.
!
Pay attention as you laminate and watch for your document appearing out of the exit at the back of the
laminator. If you do not see the document appearing after several seconds, press the REVERSE switch to
avoid a potential jam and the document wrapping around the rollers.
!
When you see your document appear at the exit, wait until it becomes free and do not tug or pull it.
9) To turn the laminator OFF after use, set the HEATER switch to OFF and allow the laminator to still run for
5 minutes (you will hear the rollers turning). This allows the laminator to cool down and it is then safe to
turn OFF.
Thank you for purchasing the Peak ID PP-110A. Peak laminators are designed to give you professional,
high quality results, quickly and easily. Please take a few minutes to read through this important document
as any
damage caused to your laminator by user error is not covered under warranty.
Don’t overlap
Leave a 5mm border
Don’t laminate open
end first
x
x
