x
x
How to use your laminator
1) Ensure the laminator is positioned on a solid, flat surface with adequate space at both the front and rear.
2) Connect the system to the power supply and turn on the power switch. The display will illuminate to indicate the
system is on.
3) Set the temperature to the required temperature on the display using the
‘Temperature Set’ buttons (see chart, this is a guide only).
4) As the laminator warms up to the desired temperature the READY light
will flash.
5) Once the laminator reaches the required temperature, the READY light will then illuminate.
6) Insert the document to be laminated into a correct size pouch, ensuring that it is centrally positioned and that an
even border (approx. 5 mm) is left around the edge. If you want to laminate a document that does not fit the size of
the pouch being used, or small cut-up pieces then you will need to use a Lifejacket®.
7) Insert the prepared item into the laminator. Ensure the pouch is always inserted SEALED EDGE FIRST.
8) The document will pass through the laminator automatically and appear out of the back. (Do not pull on the
document when you see it appear out of the laminator, wait until it becomes free).
It is important that you watch your document as you laminate in case of jamming.
If your laminating appears to be jamming, press the REVERSE button and gently ease the document back out.
Thank you for purchasing the Peak High Speed PHS-330. Peak laminators are designed to give you professional,
high quality results, quickly and easily. Please take a few minutes to read through this important document as
any
damage caused to your laminator by user error is not covered under warranty
.
Standby
button
Temperature
control buttons
Reverse
button
Speed control
buttons
Parts and Features
Diagram 1
Speed
display
Special Functions
Sleep mode (SLP) - When the laminator is left switched on and does not laminate a document for a period greater than
30 minutes, the laminator will automatically go into ‘sleep mode’ and the heating supply will cut off. The letters SLP
will be displayed on the LED display.
To reactivate the laminator, press any button.
Temperature
display
Don’t overlap
Leave a 5mm border
Don’t laminate open
end first
Ready light
Temperature
measure button
POWER SWITCH
FUSE WIRE SOCKET
WIRE PLUG
