Peak Peak 632A, Руководство пользователя

Страница: 48 / 137

PEAK 632A User Guide
BIOS Setup
4-
18
EDO DRAM Speed Selection
The DRAM timing is controlled by the DRAM Timing Registers. The timings programmed
into this register are dependent on the system design. Slower rates may be required in certain
system designs to support loose layouts or slower memory.
50ns DRAM Timing Type.
60ns DRAM Timing Type.
EDO CASx# MA Wait State
You could select the timing control type of EDO DRAM CAS MA (memory address bus).
The choice: 1, 2.
EDO RASx# MA Wait State
You could select the timing control type of EDO DRAM RAS MA (memory address bus).
The choice: 1, 2.
SDRAM RAS-to-CAS Delay
You can select RAS to CAS Delay time in HCLKs of 2/2 or 3/3. The system board designer
should set the values in this field, depending on the DRAM installed. Do not change the
values in this field unless you change specifications of the installed DRAM or the installed
CPU. The Choice: 2, 3.
SDRAM RAS Precharge Time
Defines the length of time for Row Address Strobe is allowed to precharge. The Choice: 2, 3
SDRAM CAS latency Time
You can select CAS latency time in HCLKs of 2/2 or 3/3. The system board designer should
set the values in this field, depending on the DRAM installed. Do not change the values in
this field unless you change specifications of the installed DRAM or the installed CPU.The
choice: 2, 3.
DRAM Data Integrity Mode