1. Carefully unpack and inspect the contents of the box. Use extreme care when cutting away
the packing materials as the cutting tool/tools can scratch the surface of the parts.
2. Verify that you have received all parts and hardware by checking what is included in the box
against the packing list below.
3. Place the Seat Cushion upside down on a protected surface. Lay the Spring Bracket in
the notch in the bottom of the seat with the short leg of the ‘L’ shape facing up. Fasten the
Spring Bracket using the (4) M6 x 1.0p x 20mm long socket head cap screws and Allen Wrench
provided. Start all screws first then go back and fully tighten.
4. With the legs of the ‘U’ shape facing up, place the Rear Leg over the Spring Bracket and
align its three holes with the respective holes in the bottom of the Seat Cushion. Note that the
Leg is symetric and does not have a specific left/right orientation.
5. Start one M10 x 1.5p x 25mm long socket head cap screw in each of the left and right side
holes of the Rear Leg. Also start the one M6 x 1.0p x 30mm long washer head socket head cap
screw in the center hole. Thread the screws but do not fully tighten at this time.
Assembly Instructions
Package Contents:
a. Base (Single Pedal or Split-Pedal)
b. Seat Cushion
c. Spring Bracket
d. Front Leg (the leg with the 2 Striker Plates)
e. Rear Leg
f. 2 Chair Springs
g. Hardware Pack including:
i. (4) M6 x 1.0p x 20mm long, socket head cap
screw
ii. (5) M10 x 1.5p x 25mm long socket head
cap screw
iii. (1) M6 x 1.0p x 30mm long washer head
socket head cap screw
iv. (4) M10 x 1.5p x 61mm long socket head cap
screws
v. (2) Long Spring Retaining Pin
Note: Split-Pedal option includes (2) Short and
(1) Long Spring Retaining Pins
vi. (2) E-Clips
Note: Split-Pedal option includes (3) E-Clips
vii. Assembly Tools
Split-Pedal Base
Assembly
Single Pedal Base
Assembly
a.
b.
e.
f.
i. ii. iii. iv. v. vi.
vii.
c.
d.
