Peachtree Audio Grand Pre, Руководство пользователя

Страница: 13 / 19

11
Tr
o
u
b
le
s
h
o
o
ti
n
g
You pick up hum and noise on
your Grand Pre from
the Computer
This can require some trial and error diagnostics. If you have music
ÀOHVDYDLODEOHRQDODSWRSFRPSXWHUFRQQHFWLWZKLOHRQEDWWHU\SRZHU
to the Grand Pre. If it works properly, with no noise, then the computer in
\RXURIÀFHLVLQWURGXFLQJDJURXQGORRSLQWRWKHV\VWHP7KLVLVQRW
uncommon. However, the Grand Pre ’ s digital inputs are transformer-
coupled to minimize this problem. If a problem persists, please feel
free to contact Peachtree Audio.
When you switch from one
source to another you get a
loud “click” or “pop”
Sometimes this is from static buildup but it should not occur consistently
over a long period of time. Contact your dealer or Peachtree Audio if this
persists.
The system using the Grand
Pre has no bass
&KHFNWKHEDFNSDQHOWRVHHLIWKHKLJKSDVVÀOWHULVHQJDJHGVHH
EDFN SDQHO SDJH 7KLV ZLOO UROORII DOO ORZ IUHTXHQFLHV EHORZ +]
and be very audible. Also, check to be sure your speakers are wired
LQSKDVHSRVLWLYHWRSRVLWLYHDQGQHJDWLYHWRQHJDWLYH
You ’ re getting no sound
through the balanced XLR
input
Be sure you have the balanced/unbalanced selector set on “balanced
XLR” see back panel page. Make sure the correct input is selected on
WKHIURQWSDQHO$X[
The Grand Pre will not
turn on
Check to be sure that both the power switch on the back panel and the
standby switch on the front panel are on. The front panel light should be
blue. It is green when in standby.
The Grand Pre turns on
but there is no sound
Be sure your system is not muted and that the Grand Pre has
been selected. Be sure your digital source is on and playing.
Be sure the Grand Pre
’ s standby button is glowing blue and that your
desired input is glowing blue. If the input button is blinking the
Grand Pre is in “mute” mode. Press the mute button on the remote
to un-mute the Grand Pre. Check to be sure your digital cable is
properly connected.
The remote control
doesn ’ t work
Please check the batteries by removing the cover on the back of the
remote. It is an infrared remote so it needs a clear line of sight to the
sensor on the front panel of the Grand Pre.
You intermittently lose
your signal on the
USB input
)LUVWWU\UHODXQFKLQJ\RXUPXVLFVHUYHUSURJUDPL7XQHV:03HWF
If your computer still doesn ’ t recognize the USB DAC unplug the USB
cable from the computer and the Grand Pre, wait a few seconds, then
reconnect. These are computer hookups, and sometimes you
’ ll lose
a signal just as with your printer or other USB device. You should
not have this problem often. We designed the Grand Pre to remain
locked on the USB signal at all times, but signal dropouts are still
possible.
Grand Pre