FB3
FB3
6. ADJUST OUTSIDE ROSE
7. INSTALL LOCK
9. REPLACE KNOB
10. RIGHT KEY HOLE POSITION
11. IN ORDER TO ADJUST THE ABNORMAL STATE OF THE KEY HOLE FACING UPWARD, THE KNOB MUST BE PULLED
OUT AND INSTALLED AGAIN. THE METHOD OF INSTALLATION IS DESCRIBED AS BELOW.
a
c
b
d
Adjust lock to fit door thickness by
rotating outside rose.
Lock will fit all doors 1-3/8" to 2"
(35mm~51mm) thick.
Latch unit must be in place before
installing lock. Be sure lock housing
engages with latch prongs and
retractor interlocks with latch tail.
DOOR
CENTER LINE
Upon installation of the lock, it may
happen that key hole faces upward or
downward as shown in the following
drawing.
It is advisable to correct all key hole to
be facing downward.
First turn the knob
clockwise until the
knob catch appears
in the small hole.
With the other hand,
turn the key
counterclockwise
within the limit of
30
°
~90
°
Install again
according to
the correct
direction.
Using a small nail
to press the knob
catch and pull the
knob out.
IMPORTANT-
Align lug on knob with narrow
slot on side of spindle and push knob
all the way in until knob catch clicks
into slot on knob.
Otherwise knob will jamb on shaft.
DOWNWARD
CORRECT
UPWARD
INCORRECT
X
TEMPLATE
62.7mm (2-15/32")
64mm (2-33/64")
4mm (5/32")
45 40 35
1-3/4" 1-9/16" 1-3/8"
Mark (
) hole
at center of door edge.
1" 25.4mm
Fit here on door edge
BACKSET 70mm (2-3/4")
54mm (2-1/8")
5mm (13/64") x2 HOLE
8mm (5/16") DEEP
FB3
REV.28/10/2009
SLOT
LUG
51
2"
BACKSET 60mm (2-3/8")
OPTIONAL
OPTIONAL
Optional For Thrubolt Installation
5. REMOVE INSIDE KNOB
8. INSTALL INSIDE ROSE
a
Use nail end of
wrench provided
to depress inside
knob catch in hole
of inside sleeve
collar and slide
knob off spindle.
Please use the disassembled tools to loose
inside rose, then draw it out.
Insert inside rose and reinforcing plate into hole,
turn the reinforcing plate clockwise until the
plate engaged with the hole, make sure the two
rose grooves face to door hole, then use tool
(either type of tool is attached) tighten inside
rose securely.
TOOL
REINFORCING PLATE
INSIDE ROSE
b
Rev 03-15