SDS pdqSMART INSTALLATION INSTRUCTION
88328 Rev1 – 5/22/20
HANDING INSTRUCTIONS
1. Remove outside lever using supplied pick in hole in
front of lever. Lever cannot be removed with pick until
key is inserted and turned 45 degrees.
2. Remove tape holding wire to chassis.
3. Pull chassis out of escutcheon and rotate chassis 1/2
turn (180°) maximum.
4. Replace chassis and attach tape.
5. Install lever (turn key while inserting).
REMOVE
TAPE
LEVER PICK
5. ATTACH READER AND
INSTALL INSIDE TRIM
Plug reader wire and chassis wire into
sockets on control board on back of
escutcheon, install escutcheon onto
door. Be careful not to pinch wires.
Secure escutcheon with (2) M4 x 12 Pan
head screws.
Install batteries and battery cover with
M3 x 12 pan head screw.
Install lever ring and inside lever – push
until lever retaining clip clicks into place.
BATTERY
COVER
INSIDE
LEVER
REMOVE
AND ROTATE
CHASSIS
LEVER
RING
READER
SOCKET
CHASSIS
SOCKET