Communication
Systems Inc.
PDI-P26LCDD Quick Start Guide
Page 3 of 7
Better Solutions Are Within Reach™
INSTALLATION INSTRUCTIONS
PDi Communication Systems, Inc. 40 Greenwood Lane Springboro, Ohio 45066 USA PH +1-937-743-6010 PH +1-937-743-5664
Document Number: PD196I127R1.DOC
could unexpectedly fall and cause injury or death.
The PDI-P26LCDD TV mounts on the wall at the foot of a patient’s bed. Select a location that is near an AC wall
outlet and that does not expose the TV to bright room lights or sunlight if possible. The LCD TV also requires
connection of both CATV cable signal and across-room wiring for the pillow speaker.
CABLE SYSTEM GROUNDING
The coax cable system connected to the PDI-P26LCDD TV should be grounded in accordance with the National Electrical
Code, ANSI/NFPA 70. The code provides guidelines for proper grounding and, in particular, specifies that the cable
ground shall be connected to the grounding system of the building, as close to the point of the cable entry as practical.
WALL MOUNTING WITH PD168-003 STANDARD WALL BRACKET
(Not supplied with TV)
1. Refer to Figure 1. Select a location on the wall
approximately 9 inches below the ceiling.
NOTE: Do not locate AC, Across-Room Wiring,
and CATV Signal outlets below the Wall
Bracket’s location as it will cause clearance
issues and interfere with the TV’s cabinet when
mounted to the bracket.
Position the Wall Bracket and locate two
mounting holes. Secure the bracket to the wall
(mounting hardware is not included).
2.
Refer to Figure 2. The TV can be mounted with
6 mm hardware (Not Provided) using a
compatible mount. To use 4 mm hardware,
please screw a M6-to-M4 adaptor (4 provided)
into each of the four mounting holes located on
the back of the TV. Position the Back Mount on
the LCD TV cabinet. Attach with four M6 x
10mm screws provided with the mount.
3.
Mate the Back Mount to the Wall Bracket
making sure the pivot pins are retained in the
“U” shaped slot. Using the pilfer security driver
packed with the hardware, secure with two
10x32 pilfer screws.
4. Connect the AC line cord, Pillow Speaker
Jumper Cable, and CATV Coax Cable.
5. The TV’s tilt can be adjusted by loosening both
Pilfer Screws, adjusting tilt, and then tighten.
M
6
x 10mm
Screws (4)
Pilfer Screws (2)
Back Mount
Wall
Mount
Figure 2
