Document Number: PD196-244R8
PD295-002
Page 17 of 28
PDi Communication Systems, Inc. 40 Greenwood Lane Springboro, Ohio 45066 USA PH 1-800-628-9870 FX 937-743-5664
Programming the Interface Module
Programming the IR Code Set
The Interface Module
sends infrared (IR) codes that mimic the set top box’s remote control. Therefore the interface must
know which set top box is being controlled to send the proper codes.
1. Enter the Interface Module Setup Menu (See
“Understanding Interface Module Setup Menus” earlier in this
manual).
2. Select menu Interface Module
SETUP 6/6”.
3.
Set “STB Model” to match the actual model of the STB.
4. Perform a factory reset (See Restoring Factory Default Settings later in this manual).
Provider
Set Top Box Model
On Screen
“STB
Model” Setting
Cablevision
Scientific Atlanta Explorer 4250HD
SciAtl/Cisco
Charter/Spectrum
Motorola DCH6200
Motorola
Charter/Spectrum
Motorola DCT2224
Motorola
Comcast
Pace DC50X
Cmcst DC50X
Comcast
Comcast PR150B
Cmcst PR150B
Comcast
Comcast RNG110
Cmcst PR150B
COX
COX 3250HD
(Scientific Atlanta Explorer 3250HD)
SciAtl/Cisco
Dish
Dish ViP211k
Dish
Dish
Dish ViP222k
Dish
Haivision
Haivision Stingray
Hai Stingray
Haivision
Haivision Mantaray
Hai Mantaray
Time Warner Cable/Spectrum Cisco DTA 271HD
SciAtl/Cisco
Time Warner Cable/Spectrum Cisco 8742 HDC
SciAtl/Cisco
Time Warner Cable/Spectrum Spectrum101-T
SciAtl/Cisco
Verizon
Motorola
