Document Number: PD196-173R8
PD295-001
Page 14 of 19
PDi Communication Systems, Inc. 40 Greenwood Lane Springboro, Ohio 45066 USA PH 937-743-6010 Fax 973-743-6554
Menu 6
Menu 6 provides STB configuration settings and firmware information.
MENU ITEM
EXPLANATION
STB Signal Input
Sets the TV’s signal type input to correspond to the STB’s
signal output. The majority of STB’s utilize modulated RF
as the signal type and is the type shown in this instruction
manual. TUNER is the default setting. Additional settings
are available for STB’s with different output signal types.
STB Channel
When the STB Signal Input is set to “Tuner”, STB Channel
sets the channel the TV tunes to view the STB’s signal.
This setting should match the STB’s “CH” switch setting
(which is usually 3 or 4) or the modulator channel number.
Restore Factory
Defaults
Press vol►to restore all interface settings to factory
defaults
Flash Intface Pwr
LED
This provides a diagnostic tool to help determine if the TV is
connected to the expected STB. If “Flash Intface Pwr LED” is
turned on, the “Power LED” on the interface module controlled by
this TV will flash to help identify the correct interface module to
the expected TV.
NOTE: This is not a stored parameter. It is set to “OFF” by
changing this selection or by cycling power to the interface
module.
Power Save
If “Power Save” is turned ON, the STB will be automatically
powered off when the TV is turned off
DTV Interface F/W
Ver
PDi Satellite Interface Firmware Version
TV CCI Ver
CCI communication protocol version reported by TV
DirecTV Command
Ver
Set Top Box (STB) Command Version reported by STB
DirecTV Status
Status of communications between the PDI Satellite
Interface and the STB.
DirecTV RID
Reports the RID of the connected DirecTV STB
INTERFACE MODULE SETUP 6/6
STB Signal Input
Tuner
STB Channel
003
Restore Factory Defaults
>
Flash Intface Pwr LED
Off
Power Save
On
DIAGNOSTICS
DTV Interface F/W Ver
V3.12
TV CCI Ver
V5.3
DirecTV Command Ver
V1.4
DirecTV Status
Connected
DirecTV RID
0000 0000 0000
Exit:SETUP/OK
Cancel:POWER
