MODEL NUMBER:
GO-GO
™
Gamer Cart
Document Number:
PD196-410R2
Assembly Instructions
Page 6 of 9
PDi Communication Systems, Inc.
▪
40 Greenwood Ln
▪
Springboro, Ohio 45066 USA
▪
Phone 800.628.9870
Mount the Column
1.
Set the base on the workbench on its wheels and set the brakes to keep the base from rolling.
2.
Turn over the column so it is resting on the handle and the bottom end is resting on the base.
3.
Near the top of the column, remove the Cover Plate as shown by removing the four (4) M6 x 10mm screws with the 4mm Hex
Wrench provided. Do not completely remove from the assembly. This step will allow free movement of the Column Plate to
gain access to connect the cables.
4.
Near the base of the column, connect the coax cable in the base to the coax cable in the column.
5.
Connect the Molex connectors for the power cord.
6.
Tip the column up and insert the bottom of column into the pocket in the base. Be sure that the column rests firmly at the
bottom of the pocket and is not pinching the cables (The Column Plate should still be moveable to ensure there is no
interference.).
7.
Slide the Trim Collar down the column so it rests flush against the Base.
8.
Attach the Column to the Base with the (4) M8 x 30 SHCS and Lock washers. Tighten to 100 in-lbs torque. The cart can now be
positioned upright on its casters.
9.
Re-position the plate and re-install the cover plate that was removed in step 3. Tighten the screws to 6 in-lbs. torque.
10.
Attach the Trim Collar to the Base with the (4) Self-
Threading screws, PD151-003-13, as shown here.
