GPSGSMSMMSMA
THROUGH-HOLE MOUNT MULTI-BAND GPS ANTENNA
INSTALLATION INSTRUCTIONS
Determine the desired installation location for the antenna. The
optimum location for mounting the antenna is a fl at surface, free
of obstructions, offering a clear view of the horizon and above in
all directions.
Minimum mounting surface thickness required is 0.040 inches
(0.10 cm).
Antenna is designed to be mounted through a 0.48 inch (1.22
cm) diameter or 0.75 inch (1.90 cm) diameter hole through the
mounting surface. Note that the antenna assembly includes a
slotted adapter washer for use only when installing through a
0.75 inch (1.90 cm) diameter hole.
Drill a hole through the mounting surface.
Clean mounting surface and bottom of the antenna.
Feed cables through the mounting hole.
On the bottom side of the mounting surface, slide the slotted
washer (if installing in a 0.75 inch diameter hole) around the
cables. Ensure the smaller diameter side of the washer is head-
ing up.
Remove the adhesive paper liner from the bottom of the antenna.
Press the antenna towards the mounting surface and hold the
washer at the same time (if adapter washer is being used).
Slide the hex nut on the bottom side around the cables and
tighten securely to the mounting stud.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
GPSGSMSMMSMA
THROUGH-HOLE MOUNT MULTI-BAND GPS ANTENNA
INSTALLATION INSTRUCTIONS
Determine the desired installation location for the antenna. The
optimum location for mounting the antenna is a fl at surface, free
of obstructions, offering a clear view of the horizon and above in
all directions.
Minimum mounting surface thickness required is 0.040 inches
(0.10 cm).
Antenna is designed to be mounted through a 0.48 inch (1.22
cm) diameter or 0.75 inch (1.90 cm) diameter hole through the
mounting surface. Note that the antenna assembly includes a
slotted adapter washer for use only when installing through a
0.75 inch (1.90 cm) diameter hole.
Drill a hole through the mounting surface.
Clean mounting surface and bottom of the antenna.
Feed cables through the mounting hole.
On the bottom side of the mounting surface, slide the slotted
washer (if installing in a 0.75 inch diameter hole) around the
cables. Ensure the smaller diameter side of the washer is head-
ing up.
Remove the adhesive paper liner from the bottom of the antenna.
Press the antenna towards the mounting surface and hold the
washer at the same time (if adapter washer is being used).
Slide the hex nut on the bottom side around the cables and
tighten securely to the mounting stud.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
