INSTALLING THE L-BRACKET MOUNT KIT
1
Attach the L-bracket (1b) to the customer-supplied vertical pipe
using bolts 4b, 5b, 6b and 7b. Locate in the desired position.
2
Tighten 0.25” hardware.
3
With a gasket (2) on top of the L-bracket, insert the cable assem-
bly through the L-bracket and gasket. Attach the cable assembly to
the GPS antenna and tighten the connector as required.
4
Insert the four short screws (3b) through the L-bracket and gasket
and attach the antennas and tighten the screws.
Do not use captive
screws for this configuration.
5
Install weatherproofing (not provided with the L-Bracket Mount
Kit) that extends at least 2” below the bottom of the connector on the
cable assembly to directly underneath the base plate of the antenna.
INSTALLING THE COLLAR BRACKET MOUNT KIT
Refer to Figure 2.
1
Install captive screws (3a) and set screws (4a) in collar (1a), then
push captive screws (3a) through gasket (2) holes in order to retain the
gasket.
2
Insert the cable assembly, fitted with N male connector, through the
customer-supplied vertical mounting pipe, and collar and gasket assem-
bly previously prepared.
3
Attach the cable assembly to the GPS antenna and tighten the con-
nector as required.
4
Attach the collar and gasket assembly to the antenna and tighten the
captive screws (3a) into the antenna base.
5
Slide the assembly down so that the collar slides over the mounting
pipe. Tighten the set screws (4a).
6
Install weatherproofing (not included with the Collar Bracket Mount
Kit) that extends from directly underneath the flange on the collar
bracket to at least 3” below the bottom of the collar measured on the
cable assembly.
PCTEL,
Inc.
Tel.
+630-372-6800
471
Brighton
Drive
Fax
+630-372-8077
Bloomingdale,
IL
60108
Web:
http://www.antenna.com
MIS-TIMING
Rev
B
有毒有害物质或元素
部件名称
铅
（
Pb
）
汞
（
Hg
）
镉
（
Cd
）
六价铬
（
Cr6+)
多溴联苯
（
PBB
）
多溴二苯醚
（
PBDE
）
天
线塑料零件
ANTENNA PLASTIC PARTS
O
O
O O O O
天
线金属零件
ANTENNA METAL PARTS
X
O
O O O O
电缆装置
CABLE ASSEMBLY
X
O
O O O O
固定架塑料零件
MOUNT ASSEMBLY PLASTIC PARTS
O
O
O O O O
固定架金属零件
MOUNT ASSEMBLY METAL PARTS
X
O
O O O O
O
：表示该有毒有害物质在该部件所有均质材料中的含量均在
SJ/T 11363-2006
标准规定的限量要求以下。
X
：表示该有毒有害物质至少在该部件的某一均质材料中的含量超出
SJ/T11363-2006
标准规定的限量要求。
这张表意欲只联络服从与中国要求
;
它不意欲联络服从与欧共体
RoHS
任何其
它环境要求.
MIS-TTT-ANTCBLMNT
