FW5 FloW Building Instruction Juni 2010
7.1 Push rods
The push rods are made of
CFR-pipes
, into which you glue a
bent 1mm steel wire
. A
0.5-0.8mm steel wire
will serve as
protection
against dismantling.
First you must
sand
the hook
thoroughly
.
Then you drop
thin
super glue
on the
prepared spots and
push the hook into
the pipe.
Before you glue the hook on the other end of the carbon pipe,
mount the push rod in the fuselage and switch on the radio
control. Fix the hook after trimming
in the right position
with
super glue
.
Note that you must
pull out the hook
to
apply super glue
and then push it back again.
It is
not enough
to let the super glue run into the pipe when
the hook is already inside.
www.pcm.at
16
