© PCE Instruments
4
6.1
Pass/Fail measurement
With the Pass/Fail function, colours can be compared to each other. To access this function, press
and hold the key on the meter for two seconds. The meter switches directly to this mode. The
measurement can be made directly. If the measured value is within the set parameters, "PASS"
is displayed and the display appears in green. If the measured values are outside the parameters,
"FAIL" is displayed and the display turns red. To return to normal measuring mode, press and
hold this key again for two seconds.
Note:
To be able to make settings to the meter, an Android-capable end device with a Bluetooth
interface is required.
7
App connection
In order to connect the meter to an Android-enabled meter, the meter must have a Bluetooth
interface. To make settings, the PCE-XXM 30 app must be downloaded. This app can be found
in the Play Store.
7.1
Establish connection
After installing the app, it can be opened directly. A connection to the meter can then be
established via the "Connect" button. If necessary, you will be asked for a recommended
calibration after the connection has been established.
Note:
The connection must not be made via the Bluetooth setting of the mobile end device. The
connection must be established via the app.
