© PCE Instruments
4
5
Preparation
1.
Open the battery compartment on the back of the meter.
2.
Insert the supplied batteries into the battery compartment, observing correct polarity.
3.
Close the battery compartment.
4.
Fully charge the batteries.
Attention!
Only batteries with a nominal voltage of 1.2 V may be used.
6
Battery indicator
Battery level
Battery is being charged
Battery fully charged
Mains operation without inserted battery
Battery temperature too high
The charging process is interrupted if the battery temperature exceeds 45 °C. The unit
switches off. The display flashes at 10 second intervals.
7
Operation
7.1
On / off
To switch on the meter, press the
"③
On / Off, Menu" key.
When switching on, make sure that the probe is at least 10 cm away from the object to be
measured.
To switch off the meter, press and hold the
"③
On / Off, Menu" key for approx. 3 seconds.
Automatic power off takes place after the inactivity time set in the menu.
7.2
Menu (settings)
Press the
"③
On / Off, Menu" key to open the menu.
6 options are available.
•
Measure (measurement settings)
•
Calibration
•
Limit (threshold values)
•
Memory
•
View (display indications)
•
Settings
You can make changes and settings within the menu as follows. Use the
"①
Up" or
"②
Down"
keys to navigate to the desired option and confirm with the
"⑤
OK" key.
Within the sub-menus, you can also navigate to the desired option by pressing the
"①
Up" or "
②
Down" keys.
Depending on the option, you can press the
"⑤
OK" key to change an option directly or to move
to the next lower menu level.
Proceed in the same way in the lower menu levels.
