© PCE Instruments
10
7
Data logging (PCE-322A, PCE-323 only)
To record the measurement data, press the "REC" key. REC" appears on the display. To interrupt
the recording, press the "REC" key again.
7.1
Clearing the memory
As soon as "Full" is shown on the display, the memory must be
cleared for further recording. To do this, switch off the meter.
Now press and hold the "REC" key and switch the meter back
on. As soon as "CLA" is displayed flashing, release the "REC"
key. The measurement is resumed and the memory is cleared.
7.2
Setting the memory interval
To set the memory interval, first switch off the meter. Press and
hold the backlight key and switch the meter back on. As soon as
"Int" is displayed, you can release the backlight key. Use the
"LEVEL" key to adjust the displayed value. A memory interval
between 1 ... 59 seconds is available for selection. When the
memory interval has been set, you can accept this value by
pressing the "HOLD" key.
8
Replacing the battery
As soon as the battery indicator appears on the display, the battery must be replaced. To replace
the battery, first switch off the meter and disconnect all cables. The battery compartment is located
on the back. Open the battery compartment by first unscrewing the screw with a screwdriver.
Remove the battery and insert a new 9 V block battery. Then screw the battery compartment back
in place. Now you can resume the measurement.
