© PCE Instruments
21
Eng
li
s
h
4
Getting started
4.1
Power supply
The meter is powered by a rechargeable lithium polymer battery. For charging, connect the meter
to the power supply via the USB cable. If the meter is turned off and the connection is correct, a red
LED will glow during charging.
4.2
Start-up
To start the device, press and hold
for approx. 3 seconds, until the green LED below the PCE
logo starts glowing. The main menu will be shown as start screen. Make the following settings first.
To do so, go to “Settings“ by pressing the navigation key
and confirm with Enter
.
4.2.1
Date and time
In the sub-
menu “Settings“, use the
keys to go to “Date/Time“ and
confirm with Enter
. Press F1
and select the month and year with
the
keys. Then release F1
and select the day. Confirm with
Enter
to get to the time setting.
Set the minutes by using the navigation keys
. Press the Menu key
to go to
„Hours“. When this field has been selected, it will be bordered
in red. Set the hours with the navigation keys
. Confirm your entry
by pressing Enter
.
4.2.2
Sensors
The sensor setting is only relevant for vibration measurement. In the sub-menu
„Settings“, use the
keys
to go to
”Sensors“ and confirm with Enter . Use the
keys to set the sensor used
for vibration measurement. You can choose either the IEPE sensor (Sensor1) or a sensor with
charge output (Sensor2). Navigate to further settings with the Menu key
.
“Type“, “S.N“ and
“Sens.“ can be changed via the keys
and the respective digit of the value can be selected via
the navigation keys
. Under
“Units“, the
unit for the respective sensor can be set to
mV/g
or
pC/ms
2
.
The IEPE sensor is pre-selected.
Содержание VM 20
Страница 35: ...PCE Instruments...
