8
5.4 Measuring
When the parameters are set up and the cut-off samples
length is decided, it will come to measurement. Point the
Stylus mark
to the measured area stably and then
press the Start Key on the top to start measurement, OLED
will read “Testing”. At this time, it will be invalid to press the
start button.
After the “Testing”
has
disappeared two audio indications
will sound indicating
the measurement has being finished,
and the screen will show the measured value.
Note:
1)
During the pickup’s travel, do your best to make sure
the tester is on the measured surface stably so as to
avoid its influence to the precision.
2)
During the pickup return to its previous position, the
tester will not make any response to further
operation.
3)
If the tester battery is dying, you must press
the
Reset Key , and then you can use it again.
