© PCE Instruments
9
6.2.6
Program sampling menu description
After setting the single sampling quantity, sampling times and sampling interval, press the START
button to start program sampling. The grouping, location and delay of program sampling are
saved by calling up the corresponding parameters of standard sampling directly. The total number
of samples will be displayed in the data in the next row after setting the values of single sampling
amount and sampling number.
After pressing START, the sampling delay is carried out first. After the delay is completed, a single
sampling is started and the sample size is equal to the set single sampling amount. After the
sampling of single sampling quantity is completed, the sampling times will be automatically
reduced by 1 and the sampling will stop. At the same time, the countdown of the sampling interval
starts. When the countdown of sampling interval changes to 0, a single sampling is started again.
Do this until the STOP button is pressed or the sampling number becomes 0.
Setting range of single sampling quantity: 10-3000 (minimum setting amount: 10)
Setting range of total sampling times: 0-99
Sampling interval setting range
：
0-99
Note 1
The value of single sampling amount * total sampling times should be less than 6000. If it is higher
than 6000, the set modification parameters will automatically change to the corresponding
minimum setting value.
Note 2
The total estimated time should be less than 99:59:59. If it is higher than this value, the set
modification parameter will automatically change to the corresponding minimum setting value.
