2
Ⅱ
.Panel Description
1.Transformer Jaw
This is used to pick up current signal.To measure DC/AC current,
conductor must be enclosed by the jaw.
2.Transformer Trigger
This is used to open the jaw.
3.Function Selector Switch
This is used to select the function user desired, such as ACV ,ACA,ohm
and continuity.
4.Frequency Selection Switch
At 50/60Hz position,only the low frequency signal is measured.At wide
position,signal from 40-1KHZ is measured.
5.Data Hold Button
once this button is pushed,reading shall be held on the LCD. Press
again to release it.
6.Max/Min Hold Button
This button is used to enable the maximum or minimum value to be
displayed and updated during measurement. Press once, minimum
value shall be displayed and updated. press again, maximum value shall
be displayed and updated. Press again (the third push ),clamp meter
return to normal measurement mode.
7.Zero/Relative Button
once this button is pressed, the current reading shall be set to zero and
be used as a zero reference value for all other subsequent
measurement.
