22
Motherboard User’s Guide
This page sets up some parameters for peripheral devices connected to the
system.
CMOS Setup Utility – Copyright (C) 1985-2005, American Megatrends, Inc.
Integrated Peripherals
Help Item
Allows BIOS to Enable
or Disable Floppy
Controller.
3F8/IRQ4
3FB/IRQ3
Full Duplex
378
ECP
DMA3
IRQ7
Both
IDE
Auto
Enabled
Disabled
Enabled
Enabled
OnBoard Floppy Controller
Serial Port1 Address
Onboard IR Port
Onboard IR Mode
Parallel Port Address
Parallel Port Mode
ECP Mode DMA Channel
Parallel Port IRQ
Parallel ATA IDE Controller
OnBoard SATA-IDE
HDAC Audio Controller
Ethernet Device
LAN Boot ROM
OnBoard USB Function
USB Function For DOS
: Move Enter: Select +/-/: Value F10: Save Esc: Exit
F1: General Help F9: Optimized Defaults
Enabled
Parallel Port Address
Use this item to set the parallel port mode. You can select ECP (Extended
Capabilities Port) & EPP (Enhanced Parallel Port).
DRAM Timing
This item allows you to set up the DRAM timing automatically.
Share Memory Size
This item shows the VGA memory size borrowed from main memory capability.
In this case, 64MB is borrowed, which in the meanwhile the same the main
memory loses.
Integrated Peripherals Page
DRAM Driving
When this item is defaulted at “Normal”, some DDRs might cause the problem
of booting or system stability; in that case, please set it at “High”.
Parallel Port Mode
Use this item to enable or disable the onboard Parallel port, and to assign a port
address.
Use this item to set the onboard IR mode.
OnBoard IR Mode
Use this item to enable or disable the onboard infrared port, and to assign a port
address.
OnBoard IR Port
Use this item to enable or disable the onboard COM1/2 serial port, and
to assign a port address.
Serial Port1 Address
Use this item to enable or disable the onboard floppy disk drive interface.
OnBoard Floppy Controller