PBI SAS SUPER IAQ, Инструкция по эксплуатации, Страница: 10 / 41

“
SAS Super IAQ” Rev. 1 Pg. 6
ENGLISH
I
D
X
X
X
X
S I T E X X X X
S
T
A
R
T
F
O
R
X
X
M / D / Y - H : M
Push START button
to start air sampling
with last cycle
(
X
X
)
X
X
M / D / Y - H : M
The motor will run until the figures in brackets reach the same figure as displayed to the right
and then it will stop. During the sampling the two red leds are flashing
(see position 16 and 28
in the figures at page 24).
3.4 “55 mm CONTACT PLATES” HOLDER ADJUSMENT
The Contact Plate holders can be adjusted (using a screw driver) in case the available plates
slightly different in diameter from the standard 55 mm Contact Plate (see the figure in the
Chapter 4.10).
3.5 “84 mm MAXI-CONTACT PLATES”
If high fungal contamination is expected in the sampled air, Maxi-Contact Plates are suggested.
This is because moulds tend to spread and consequently make counting difficult after
incubation.
The “84 mm Maxi-Contact Plates” are inserted into the SAS SUPER IAQ using a special
adaptor (Cat.n. 19123). For more details see Application Note N. 89.