Brighten Your Digital View!
3
www.pbi-china.com
3.3 The fuses
The recognized recommended fuses are size 5 by 20 mm, rate T 2.0A, 250 V (UL and IEC
approved).
The line fuse is housed in a small container besides the power connector on the rear panel.
To check the fuse, insert the tip of a screwdriver in the slot at the middle of the container and pry
gently to extend the fuse where there is a little tap and pull out the fuse gently. The fuse is
attached to the line module and cannot be removed.
3.4 Connecting Up the Device
Always use the specified cables supplied for signal integrity and compliance with EMC
requirements.
The rear panel is directly related to the input and output options fitted. Below figure shows a
typical rear panel.
B1
TS/IP
IP input/output port
B2
RS-232
serial port for printing information
B3
MANAGEMENT
LAN port for software update
B4, B7
ASI OUT2
Group2 ASI output port (one for back-up)
B5, B8
ASI OUT1
Group1 ASI output port (one for back-up)
B6
ASI1 IN
ASI1 input port
B9
ASI2 IN
ASI2 input port
B10
SDI2
SDI2 output port
B11
SDI1
SDI1 output port
B12
HDMI
HDMI output port
B13
CVBS
CVBS BNC output port
B14, B15, B18
YPbPr
YPbPr output port
B16, B17
L-Audio-R1
Group1 RCA audio output port
B19
CVBS
CVBS RCA output port
B20, B21
L-Audio-R2
Group2 RCA audio output port
B22
Audio1
AES/EBU and Balance Audio output port1 (need to use
the RS232-to-XRL converting cable in accessories)
B1 B2
B3
B4
B5 B6
B7 B8 B9
B10
B11 B12 B13
B14 B15B16 B17
B18B19 B20 B21
B24 B25 B27
B26 B28
B23
B22