English
18
Auto Talk On/Off
With auto talk is turned on, you can answer a call just by lifting the handset off the base or charger. If
turned off, you will have to press
F
to answer a call. The default setting is Off.
1. Press
S
and
E
and
D
to select
SETUP HS
.
2. Press
S
and
E
and
D
to select
AUTO TALK
.
3. Press
S
and
E
and
D
to turn on/off auto talk.
4. Press
S
to save.
Registration
The original handset is pre-registered with base station to use.
Although one base station can be registered with more than one handset, this feature is not
recommended.
To register an additional handset,
1. Press
S
and
E
and
D
to select
SETUP HS
.
2. Press
S
and
E
and
D
to select
REGISTRATION
.
3. Press
S
and
E
and
D
to select
YES or NO
.
4. Select
YES
and press
A
to enter the registration procedure as below:
• Place the unregistered cordless handset on the charger.
• Press and hold
A
for 4 seconds on base. And then release
A
.
• A confirmation tone is generated if registration is successful.
HANDSET X
is displayed
where
X
denotes the number of handsets and the phone goes back to idle.
ADVANCED SETTINGS
Set the Dial Mode
The default dialing mode is suitable for your country and network operator. It is unlikely that you
should need to change this setting unless advised to do so.
1. Press
S
and
E
and
D
to select
SETUP BS
.
2. Press
S
to select
DIAL MODE
.
3. Press
S
and
E
and
D
to select
TONE
or
PULSE
.
4. Press
S
to save.
NOTE
:
If pulse mode is selected, press
*
to switch from pulse to tone dialing temporarily
when dialing out. After the call is ended, the dial mode will resume to pulse.
Set the Flash Time
The default dialing mode is suitable for your country and network operator. It is unlikely that you
should need to change this setting unless advised to do so.
1. Press
S
and
E
and
D
to select
SETUP BS
.
2. Press
S
and
E
and
D
to select
FLASH TIME
.
3. Press
S
and
E
and
D
to the flash time you want. (8 options are available: 90, 100, 110, 250,
300, 400, 600 and 700MS)
4. Press
S
to save.
Set the Area Code
1. Press
S
and
E
and
D
to select
SETUP BS
.
2. Press
S
and
E
and
D
to select
AREA CODE
.
3. Press
S
and enter the area code.
4. Press
S
to save.
Reset All Settings
All personalized settings will be reset to default. Phonebook entries, calls list and redial list will
remain unchanged.
1. Press
S
and
E
and
D
to select
RESET SETTINGS
.
2. Press
S
and
E
and
D
to select
ALL SETTINGS
.
3. Press
S
to select
YES
.
4. Press
S
to reset all settings to default.
Retro_EN.book Page 18 Thursday, September 3, 2009 9:50 AM
