4
V88A SPARK ONLY 9183R REV.1 (MM/YY)
1. STOP! Read the safety information above on this
label.
2. Set the thermostat or operating control to lowest
setting.
3. Turn off all electric power to the appliance.
4. This appliance is equipped with an ignition device
which automatically lights the pilot. Do not try to light
the pilots by hand.
5. If the gas control assembly is not visible, remove
control access panel.
6. If the manual shutoff lever(s) and pilot cock are not in
the "OFF" position, turn both clockwise to "OFF".
7. Wait five (5) minutes to clear out any gas, then smell
for gas, including near the floor. If you smell gas
STOP! Follow "B" in the safety information above on
this label. If you don't smell gas, go to the next step.
8. Turn the pilot cock and the manual shutoff lever
counterclockwise to "ON".
9. Replace pilot access panel, if applicable.
10. Replace control access panel, if applicable.
11. Turn on all electric power to the appliance.
Manually reset open limits and burner primary
control. For boilers equipped with a Peerless
Control Panel, place panel switches to "ON". Alarm
may activate (if used). If so, switch alarm silencing
switch.
12. Set thermostat or operating control to desired
setting.
13. If the appliance will not operate, follow the
instructions "To Turn Off Gas To Appliance" and
call your service technician, or gas supplier.
A. This appliance is equipped with an ignition device
which automatically lights the main pilots. Do not try
to light the pilots by hand.
B. BEFORE OPERATING smell all around the appliance
area for gas. Be sure to smell next to the floor because
some gas is heavier than air and will settle on the
floor.
WHAT TO DO IF YOU SMELL GAS
Do not try to light any appliance
Do not touch any electric switch;
do not use any phone in your building
Immediately call your gas supplier from a neighbor's
phone. Follow the gas supplier's instructions.
If you cannot reach your gas supplier, call the fire
department.
C. Use only your hand to push in or turn the gas control
knob. Never use tools. If the knob will not push in or
turn by hand, don't try to repair it, call a qualified
service technician. Force or attempted repair may
result in a fire or explosion.
D. Do not use this appliance if any part has been under
water. Immediately call a qualified service technician
to inspect the appliance and to replace any part of the
control system and any gas control which has been
under water.
WARNING: If you do not follow these instructions exactly, a fire or explosion may
result causing property damage, personal injury, or loss of life.
FOR YOUR SAFETY READ BEFORE LIGHTING
OPERATING INSTRUCTIONS
TO TURN OFF GAS TO APPLIANCE
1. Set the thermostat or operating control to lowest setting.
2. Turn off all electric power to the appliance if service is
to be performed.
3. If the gas control assembly is not visible, remove the
control access panel.
4. Turn the pilot cock and the manual shutoff lever
clockwise to "OFF".
5. Replace control access panel, if applicable.
Pilot Cock
(shown in "OFF"
position)
FLOW
Manual Shutoff Lever
(shown in "OFF"
position)
Figure 2: Operating Instructions, Spark Ignited Pilot
