PAGE 3
Option
Part number
Description
K50 & KP50
Fitting Kit fk1-059
(5) Cable clips
(3) No6 x
3
/4
woodscrew - zinc
(3) Wall plugs 22mm
(1) 8mm x 3mm small self tapping screw - zinc
K75 & KP75
Fitting Kit fk1-061
(5) Cable clips
(3) No8 x 1 woodscrew - zinc
(3) Wall plugs 35mm
(1) 8mm x 3mm small self tapping screw - zinc
Fitting Kit
Standard Unit - Drill a hole in the surface for the rear data cable. Secure the unit to the surface with three screws
as per fitting diagram on page 1. 3 suitable screws and fixings are provided for fitting the unit to a wall. Ensure
the data cable has free access at the rear.
A choice of black and white covers are also provided. Hook the required cover over the top of the reader, press
home at the bottom and secure with the single fixing screw.
Screw Terminal Unit - The adapter (310-750-US) is mounted to a standard backbox using the fixing screws
provided. The 75mm reader is then mounted onto the adapter using the fitting kit provided with the reader.
KP series - When chosing a location for the reader, ensure that it is a least 12 inches from other readers. This will
include readers mounted on the other side of the same wall as the radio signal will cause interference and reduce
the read range. The reader should not be used on metal surfaces as the reflected signal will also reduce the range.
Powering up the keypad will cause all the LEDs to come on. Once the control unit has been configured to accept
keypad input (see controller instructions) pressing any key will make the keypad sound a bleep. Check the
following FAQ section for assssistance if any problems are encountered.
FCC Compliance
Class B digital devices.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
Class A digital devices.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can radiate radio energy and, if not installed and
used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the
interference at his own expense.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
This unit is for Indoor use only
Following the completed installation of this equipment, no further maintenance or testing is required.
It is advisable to ensure that any third party backup power supplies or recovery procedures are checked regularly
to ensure that the operation of the Paxton system is not compromised.
Unit installation / test Maintenance
/
