background image

2

 

P o we r  

F e e d  

3 .  

Insert the battery with contact end first. 

4 .  

Close the battery door. 

5 .  

Lock the battery door by sliding 
up the tabs.   

To remove the battery, partially 
open the battery door and tip out 
the battery.  If the battery door is 
completely open, the hinge prevents 
the battery from falling out. 

C h a r g i n g   t h e   B a t t e r y  

The printer’s battery must be charged before using it.  The battery 
can be charged  

♦ 

using the single or four-station charger.   

♦ 

inside the printer using 
the plug-in charger for 
select printers.  However, 
not all printers allow 
the battery to be 
charged inside the 
printer. 

1 .  

Plug the cable into the 
socket located on the side of 
the printer. 

2 .  

Insert the plug-in charger into an electrical outlet.  Charging time 
is approximately 1.5 hours. 

U s i n g   t h e   A C   A d a p t e r  

Some printers use an AC adapter, which allows you 
to use the printer while it is plugged into a wall 
outlet.  Using the AC adapter eliminates the need to 
charge the battery, since the printer operates on AC 
current instead.   

1 .  

Connect the plug to the AC adapter. 

2 .  

Plug the cable into the socket located on the side 
of the printer.  

3 .  

Plug the AC adapter into an electrical outlet. 

C o n n e c t s   t o   p r i n t e r  

Содержание Monarch Sierra Sport 3R 9430R

Страница 1: ...tage is below 5 0V the battery is trickle charged until the battery reaches 5 0V Amber Off The battery is fully charged Green On The printer is on and ready to accept data If there is no activity for longer than 20 30 seconds the printer goes into sleep mode to conserve the battery The printer wakes up when it receives any information from the host or you press the power P button With Bluetooth pr...

Страница 2: ...harger for select printers However not all printers allow the battery to be charged inside the printer 1 Plug the cable into the socket located on the side of the printer 2 Insert the plug in charger into an electrical outlet Charging time is approximately 1 5 hours U s i n g t h e A C A d a p t e r Some printers use an AC adapter which allows you to use the printer while it is plugged into a wall...

Страница 3: ...receipt paper 1 Lift up the T lever on the supply door and wrap your fingers around it 2 Pull up firmly on the supply door to open it 3 Drop the supply into the well Make sure the supply unwinds from the bottom 4 Position the supply between the printhead guides 5 Make sure 2 3 inches of supply extends past the printhead 6 Close the supply door T e a r i n g S u p p l y The printer s supply door ac...

Страница 4: ...nvironments pause the printer for one minute after every four inches printed If the duty cycle is exceeded the printer may not print all of the information that was sent to it NOTE This is not a continuous batch printer Light heavy printing or voids in printing Clean the printhead Check or recharge the battery See Charging the Battery for more information Your System Administrator may need to adju...

Отзывы: