4
Step 3:
Remove the cotter pin and retaining bolt from the frame assembly. See Figure 1.
Step 4:
Remove the two bolts from each side of the hydraulic pump holder. See Figure 2.
Step 5:
Lift the hydraulic pump up and out of the frame assembly.
Step 6:
Remove the screw holding the plastic cover for the hydraulic pump.
Step 7:
Remove the four nuts and washers holding the hydraulic pump to the pump holder. Remove the lock
washers located under the holder.
Step 8:
Attach the pump holder to the new hydraulic pump, making sure the lock washers are installed
under the holder. Put on the four washers and nuts. Tighten each nut. Re-install the pump cover.
Step 9:
Place the hydraulic pump and holder into the frame assembly and re-install the two holder bolts.
Note: Make sure the hydraulic pump is in the correct position for the foot lever to be attached.
Step 10:
Re-install the cotter pin and the retaining pin. Turn the table upright, and install the foot lever.
Tighten both set screws for the foot lever. Re-install the table top and the grooming arm.
The cotter pin and retaining bolt hold the
top portion of the hydraulic pump to the
frame assembly.
Figure 1
Figure 2
Figure 3
Hydraulic
Pump Holder
Bolt
Hydraulic Pump
Pump Holder
Pump Cover
