- 15 / 20 -
①
Panel Lock:
Click “Panel Lock” to lock/unlock panel buttons. “On” indicates that panel
buttons are unavailable; “Off” indicates panel buttons are available.
②
Beep:
Click “Beep” to turn on/off the beep.
③
LCD:
You can turn on/off the LCD, and set the turn-on time (15s/30s/60s).
④
Serial Baud Rate:
Click the value to set the Serial Baud Rate.
⑤
Firmware Update:
Click “Browse” to select the update file, then click “Update” to complete
firmware update.
⑥
Factory Reset:
You can reset the unit to factory
defaults by clicking “Reset”.
⑦
Reboot:
You can reboot the unit by clicking “Reboot”.
Note:
After reset/reboot, it will switch to the login page.
10.
RS-232 Control Command
The product also supports RS-232 control. You need a serial cable with RS-232 male head and
DB9 transfer USB male head. The RS-232 head of the serial cable is connected to the RS-232
control port with DB 9 at the rear of the Matrix, and the USB head of the serial cable is connected
to a PC. The connection method is as follows:
RS-232
Then, open a Serial Command tool on PC to send ASCII command to control the Matrix.
The ASCII command list about the product is shown as below.
ASCII Command
Serial port protocol. Baud rate: 115200, Data bits: 8bit, Stop bits:1, Check bit: 0
x - Parameter 1
y - Parameter 2
! - Delimiter
Command Code
Function Description
Example
Feedback
Default Setting
Power
s power z!
Power on/off the device,z=0~1
(z=0 power off, z=1 power on)
s power 1!
Power on
System Initializing...
Initialization Finished!
power off
power on
r power!
Get current power state
r power!
power on/power off
s reboot!
Reboot the device
s reboot!
Reboot...
System Initializing...
Initialization Finished!
FW version x.xx.xx
System Setup
help!
List all commands
help!
r type!
Get device model
r type!
ENT-MX20B8X8
