seconds, that identifies the ad-
dress setting of the energizer.
To identify your energizer’s
address setting, match what
you see on the energizer’s
display with one of the illustra-
tions to the right.
Note: If only the large, red
light segment on the left hand
side is illuminated, your ener-
gizer is set to address zero.
This means that you have a Re-
mote Ready energizer and you
will need to activate the remote
control function of the energizer
(see the section “Configuring a
Remote Ready energizer to obey commands from a handset”).
Set the handset to the same address setting as the energizer
1. Press and hold
, then press
to enter the Set-up mode.
2. Press and hold
to scroll through the list of available options.
3. Select the address (Ad) option, and press
repeatedly to scroll to the address setting you
identified earlier.
4. Press
to store the new address setting.
A moving arrow on the handset screen indicates that the address setting is being saved. After a
few seconds, the handset will automatically switch itself off.
To exit the Set-up mode without storing the new address setting:
• Instead of pressing
in step 4, which stores the address setting, press
. This switches
off the handset without storing the new energizer address setting.
Test whether the energizer is obeying commands from the handset
1. Press
to turn on the handset and move to within 150-300 mm (6-12”) of the energizer.
2. Press
or
to turn the energizer on or off.
Tip: Make a note of the energizer’s address setting to save time should the address be acciden-
tally changed, or if an additional remote control is required in the future.
Configuring a Remote Ready energizer to obey commands from a handset
Follow these instructions if you have purchased a handset for use with a Remote Ready ener-
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
0
- 19 -