12
Installing Pressure Plate Block After Cleaning
1. Before installing Pressure
Plate Block Assembly on the
hopper of the machine,
unplug
the machine from its power
source.
2. Using the Speed Driver
provided with the machine,
slightly spread the block apart
as shown in picture. Remove
the Speed Driver from the slot
before putting the block on the
hopper.
3. Place Pressure Plate in the
Pressure Plate Block and place
the block on the Hopper. Make
sure the angled section of the
block is towards the Hopper.
Place the Block Top on the
block, make sure to match the
angled section of the block top
with the angled section of the
block.
4. Place bolt through the block.
Start threading each bolt by
hand. Using the Speed Driver
with Leverage Handle provided
with the machine, tighten all
four bolts. Make sure the
pressure plate in is the block
when tightening.
5. After the block is tightened
into place, make sure the
pressure plate easily slides
through the block.
6. After assembling the rest of
the machine, jog the On/Off
Switch of the machine through
one full cycle of the machine.
Your machine is now ready for
use.
Pressure Plate Block
Speed Driver 1/2
way into Block
Angled Section of
Block and Block
Top
Hopper
Pressure Plate in
Block
Speed Driver
Make sure
Pressure Plate
easily slides in and
out
On/Off Switch
For Further Information
Contact the Factory
877-938-5244
Lever Handle
Содержание 330PUB
Страница 6: ...6 Proper Label Location for a Model 330PUB 1 2 3 4 5 6 7 8 9 10 10 11 2 6 12...
Страница 26: ...26...